E-7
Servicing the mower blades
(continued)
6. Reinstall the blade (G) with the tabs pointing up toward the
mower deck as shown. Reinstall the alignment pin (H). Be
sure the blades (M) are positioned perpendicular to each
other. If not, perform the mower blade timing procedure
found in this section.
7. Reinstall the flat washer (I), spline washer (J), spring
washer (K) and capscrew (L). Use a wooden block (B) to
prevent blade rotation while tightening the capscrew (L) to
61-75 N.m (45-55 ft. lbs.).
B
A
M
L
K
J
I
H
G
F
To Next Page
Loading...
