E-10
Transmission oil change
(continued)
5. Thoroughly clean and dry the transmission and surrounding
area (see “Clean off transmission”).
6. Place a drain pan below the transmission and remove the
drain plugs (D). Allow the transmission to drain for
approximately 10 minutes.
7. Replace the drain plugs (D).
8. Remove the fill cap (B).
9. Fill with new transmission oil. Observe the oil level. The oil
should be filled up to the bottom of the top casing notch (C).
10. Reinstall the fill cap (B).
11. Reinstall the discharge tube, mower deck and catcher.
Test run the tractor for several minutes and check the oil level.
If the transmission is excessively noisy or unresponsive,
perform the transmission purging procedure found in the
“Adjustments and Service” section.
D
C
B
A
To Next Page
Loading...
