E-11
PTO clutch adjustment
Service interval: After first 50 hours, then every 250 hours
Also perform adjustment if the clutch is slipping
1. Remove key from ignition switch and disconnect spark plug
wires to prevent the possibility of accidental starting while
the PTO is being adjusted.
2. Insert a 0,3 mm (0,010") feeler gauge (C) through each
window (A), positioning the gauge between the rotor face
and the armature face as shown.
3. Alternately tighten the adjustment nuts (B) until the rotor
face and armature face just contact the gauge.
The actual air gap between the rotor and
armature may vary even after performing the
adjustment procedure.
4. Check the mower blade stopping time. The mower blades
and mower drive belt must come to a complete stop within
five seconds after the PTO is disengaged.
B
C
A
B
B
A
B
To Next Page
Loading...
