29
Regular Maintenance
Battery Maintenance
Cleaning the Battery and Cables
SERVICE INTERVAL: EVERY 100 HOURS
1. Disconnect the cables from the battery, negative
cable first (A, Figure 21).
2. Remove the battery hold-down (C) and battery.
3. Clean the battery compartment with a solution of bak-
ing soda and water.
4. Clean the battery terminals and cable ends with a
wire brush and battery terminal cleaner until shiny.
5. Reinstall the battery in the battery compartment, and
secure with the battery hold-down (C).
6. Reattach the battery cables, positive cable first (B).
7. Coat the cable ends and battery terminals with petro-
leum jelly or non-conducting grease.
WARNING
When removing or installing battery cables,
disconnect the negative cable FIRST and reconnect
it LAST. If not done in this order, the positive
terminal can be shorted to the frame by a tool.
Figure 21. Battery
A. Negative Cable
B. Positive Cable & Cover
C. Rubber Hold-Down Strap
A
C
B
Figure 20. Tire Pressure
Check Tire Pressures
SERVICE INTERVAL: EVERY 25 HOURS
Tire Pressure should be checked periodically, and main-
tained at the levels shown in the chart (see Figure 20).
Note that these pressures may differ slightly from the
“Max Inflation” stamped on the side-wall of the tires. The
pressures shown provide proper traction, improve cut
quality, and extend tire life.
Size PSI bar
24 x 12-12 6-8 ,41-,55
23 x 10.5-12 6-8 ,41-,55
16 x 6.50-8 15 1,0
To Next Page
Loading...
Need help?
General
