Have questions? Call 0800 920 2420
10
BEDROOM
KITCHENLIVING ROOM
BATH
BEDROOM
Install your CO Detectors
Separate the mounting bracket from the
back of the Carbon Monoxide Detector by
rotating it counterclockwise.
Mount the bracket to your wall or ceiling
using the included screws and wall anchors.
1
2
3
This detector is for household use only. There are local laws that apply to CO Detectors.
Please refer to the information included in the detector box and consult with your local fire
brigade regarding any requirements.
Push the CO Detector against the mounting bracket and
rotate it clockwise until it snaps into place. A solid yellow light
means it is not snapped in place.
Do not install near your
furnace, stove, fireplace,
kitchen or garage.
Typical installation locations:
Near bedrooms and on each
level of your home.
Test Button
BOILER
ROOM
To Next Page
Loading...
