To Next PageTo Next Page
Need help?Do you have a question about the SimpliSafe Glassbreak Sensor and is the answer not in the manual?
General| Type | Glassbreak Sensor |
|---|---|
| Compatibility | SimpliSafe security system |
| Power Source | Battery |
| Battery Life | up to 5 years |
| Connectivity | Wireless |
| Operating Temperature | 32°F to 120°F |
| Detection Range | 25 feet |
| Installation | Adhesive or Screw Mount |
Utilize the Keychain Remote's Easy Setup Wizard for animated instructions and system customization.
Install smoke detectors near sleeping areas for early fire detection.
Place CO detectors near sleeping areas for hazardous gas detection.
Install the Base Station in a central location for system connectivity.
Install the Keypad near the main entrance for easy system access.
Install entry sensors on doors and windows to detect breaches.
Mount motion sensors 4-5ft high in corners for optimal room coverage.
Install panic buttons in master bedrooms for immediate emergency alerts.
Set up the Base Station in a central house location, avoiding the floor.
Plug the Base Station into a power outlet, ensuring it's not on a light switch.
Remove the battery strip and adhere the Keypad to a wall near the main entrance.
Activate your subscription online to enable professional monitoring and dispatch.
Change your default 4-digit PIN to a new, secure personal identification number.
Arm the system in Away or Home mode when leaving or staying home.
Use Away mode when leaving; all sensors active. 60-second exit delay.
Use Home mode when staying home; motion sensors inactive. Entry sensors active.
Arm the system in Away or Home mode when leaving or staying home.
Access test mode via the Keypad menu (option 5) to test system functionality.
Test each sensor type by following specific activation and confirmation steps.
Test motion sensors by pressing the button underneath; wait 15 seconds.
Test glassbreak sensors by pressing the button and clapping near windows.
Test entry sensors by opening and closing protected doors/windows.
Test panic buttons by holding the button down for 1 second.
Test smoke detectors by holding the front test button for 4 seconds.
Test CO detectors by holding the front test button for 4 seconds.
Test water and freeze sensors by pressing the button on top of each.
Manage components (add/remove) using the Keychain Remote and computer wizard.
Add or remove components using the Keypad menu system and voice prompts.
Resolve 'Entry Sensor open' warnings by closing doors/windows or checking alignment.
Resolve sensor errors by checking proximity, batteries, or removing the sensor.
Check service activation, Base Station location, or landline connection for dispatch issues.
