Simpson 260 - Page 14

ACCESSCRIES SUPPLIED
LEAD SET (Part #3638): Two 4? leads, one red, one
black, with molded right angle connector plugs and
rubber sleeved alligator clips are supplied with
each instrument, The wire is finely stranded and
very flexible, and the insulation safe for all volt-
ages to which your instrument will be subjected.
Nevertheless, when measuring high voltages, ob-
serve the standard precaution of clipping the lead
to the connection with power off. Then restore
power and read the instrument, keeping the hands
clear of leads and equipment.
ACCESSORIES AVAILABLE
LEAD SET (Part #3686): Аз above, but with test
prods instead of alligator clips.
HIGH VOLTAGE D.C. PROBE (Part #0247): 25 KV probe,
tubular plastic handle housing multipliers.
CASES (Part #7031-1): Brown leather "Eveready"
style, into which the instrument can be permanently
fastened with the handle mounting studs. Front
flap lifts up to expose the whole front panel in use.
(Part #7237): Black leather pouch type.
ADD-A-TESTER UNITS: These are too numerous and
complex to describe fully in this manual. However,
by plugging the desired unit into your instrument,
you can convert the latter to function as a trans-
istor or temperature tester, DC VTVM, Audio Watt-
meter, Battery Tester, AC Ammeter or Microvolt At-
tenuator. Your present case must be replaced with
one designed to lock the Add-A-Tester in place.
Conversion kits are available, See Parts List.
12