Simpson 260 - Page 16

Step Де
2.
6.
7.
VCLTAGE
OPERATING INSTRUCTIONS
Connect the black test lead to the
negative side of the circuit to be
measured, and the red lead to the
positive side of the circuit.
Turn on powere If the meter deflects
to the left of zero, switch off prompt-
ly and reverse the connections (the
function switch with its polarity re-
versing feature is not in circuit on
this range). Restore power.
Read voltage on the black are marked
DC. Use the figures 0-250 which give
a direct reading in millivolts.
Turn off power and disconnect leads.
RANGES TC 1000V.
CONTACTS AND SWITCH POSITIONS FOR D.C. VOL TS.
14