Simpson Clean Machine CM60912 - Page 9

9 - ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray
wand into the end
of the spraygun.
5
Connect QC
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure incoupler.
6
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold WaterOnly.
7
Release Air from
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30seconds.
8
Verify the
Engine Switch
is turned to the
ON Position
9
Verify the Choke
Pin is pulled out
to the CHOKE
position
The Choke Pin has been
preset by the factory to
be in the CHOKEPosition.
10
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start theengine.
11
Push the Choke
Pin in to the
RUN Position
Gradually move the
Choke Pin to the
RUN Position after
enginestarts.
WARNING: This Guide is not a substitute for reading the operator's manual. User
must read and understand operator's manual before using thisproduct.