T-SAS-GCNM12 ©2012 Simpson Strong-Tie Company Inc.
-4-
SAFE HANDLING OF GCN TOOLS AND FUEL CELLS
1. NEVER attempt to force a fuel cell into or out of the fuel compartment.
2. NEVER use a sharp or pointed object to install or remove the fuel cell, this may
cause an accidental discharge, or may puncture/damage the fuel cell, creating a
hazardous condition.
3. NEVER attempt to service a jammed tool with the battery and fuel cell installed.
4. If at any time during the operation of the tool you feel it is not working properly,
STOP using it and call your Simpson Strong-Tie representative.
5. If unnecessary bystanders are in the area tell them to leave,
warn all others that you are using a gas actuated tool.
6. Check the work surface to be sure it is clear of any debris.
Clear away any debris so that the tool sits ush on the work surface.
7. Check the work area for explosive or ammable materials.
If any are found remove them before operating the tool.
8. Remove any debris from the tool barrel before operating.
9. Check the air lter for cleanliness and condition; if necessary, replace with new
lter (part # GCN-BC0597) or clean prior to operating tool.
10. NEVER load more than one fastener in the barrel or fastener guide for any reason.
11. Should a tool become disabled for any reason, immediately remove the fuel cell
and battery, and tag the tool “Defective Tool.” Do not resume operation until the
disabled tool has been repaired according to manufacturer’s instructions.
For cleaning procedures, please refer to www.strongtie.com/GCNcleaning
To Next Page
Loading...
