Need help?Do you have a question about the Simpson GCN150p and is the answer not in the manual?
General safety precautions for operating GCN tools and fuel cells, including pointing the tool away, not covering the front, and using PPE.
Evaluate base material suitability and thickness using the center punch test to ensure safe fastening.
Key guidelines for safe fastening, including tool angle, fastener placement, and material considerations.
Details on suitable concrete and masonry materials for fastening, and factors affecting holding power.
Information on fastening into steel, common types, and factors affecting holding power.
Selection guide for GDP collated pins, including model numbers and compatible nailers.
Selection guide for GDP collated step-shank pins, including model numbers and compatible nailers.
Selection guide for GDP collated spiral-knurled pins, including model numbers and compatible nailers.
Selection guide for mechanical, electrical, and plumbing pins, including model numbers and compatible nailers.
Information on gas fuel cells for GCN tools, including model numbers, pack quantities, and compatible tools.
Detailed steps for preparing and installing the GFC34 fuel cell into the tool.
General| Power Source | Pneumatic |
|---|---|
| Operating Pressure | 70 - 120 PSI |
| Nail Length | 1.5 inch to 3.5 inch |
| Nail Type | Round head |
| Width | 4.5 inches |
| Nail Gauge | 0.113 to 0.131 inches |
To Next Page
