Simpson MSH3125 - Connecting Components and Initial Operation; Hose and Wand Connections; Water Supply and Air Release; Starting the Engine

9 - ENG
1
Connect
Garden Hose to
Pump
Thread the garden hose
to the pumpinlet.
2
Connect High
Pressure Hose
to Pump
Connect the high
pressure hose to
the pumpoutlet.
3
Connect High
Pressure Hose
to Spray Gun
Thread the other end
of the high pressure
hose to the spray gun.
4
Connect Spray
Wand to Spray
Gun
Thread the spray
wand into the end
of the spraygun.
5
(if equipped) QC
Nozzles
Connect QC
Nozzles to Spray Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure incoupler.
(if equipped)
5 n 1 Nozzle
Select a spray pattern
Rotate the spray selector
to the desired setting
6
Turn Water
Faucet
Completely On
Do not run the
unit without water
supply connected
and turned on. Use
Cold WaterOnly.
7
Release Air
from System
Release all
air from pump and
high pressure hose
by depressing trigger
until a steady stream
of water is present.
Approximately
30seconds.
30 S
8
Start engine. See
Engine Owner's
Manual for
correct
procedure.
WARNING: This Guide is not a substitute for reading the operator's manual.
User must read and understand operator's manual before using thisproduct.