EasyManua.ls Logo

Simpson MSH3224 - RISK TO BREATHING (ASPHYXIATION); VENTILATION AND EXHAUST SAFETY; RISK OF FLUID INJECTION AND LACERATION; SAFE HANDLING OF HIGH-PRESSURE FLUIDS

Simpson MSH3224
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
& DANGER: RISK
TO
BREATHING (ASPHYXIATION}
HOW
TO PREVENT IT
Operate pressure washer in a well-
ventilated area. Avoid enclosed
areas
such
as
garages, basements, etc.
Breathing exhaust fumes will
cause
serious injury
or
death! Engine
exhaust contains carbon monoxide,
an
odorless
and
deadly gas.
Never operate unit in
or
near a location
occupied
by
humans
or
animals.
Some cleaning fluids contain
substances which could
cause
injury
to skin,
eyes
or
lungs.
Use only cleaning fluids specifically
rec-
ommended for high pressure washers.
Follow manufacturers recommendations.
Do
not
use chlorine bleach
or
any other
corrosive compound.
~
& DANGER: RISK OF FLUID INJECTION
AND
LACERATION
WHAT CAN HAPPEN
HOW
TO PREVENT IT
Your
pressure washer operates
at
fluid
pressures
and
velocities high enough
to penetrate human
and
animal
flesh
which could result
in
amputation
or
other serious
injury.
Leaks caused
by
loose
fittings
or
worn
or
damaged
hoses
can result in injection
injuries.
DO
NOT
TREAT
FLUID INJECTION
AS
A SIMPLE CUT! See a physician
immediately!
Inspect the high pressure
hose
regularly.
Replace the
hose
immediately
if
it
is
damaged, worn, has melted from
contacting the engine,
or
shows
any
signs
of
cracks, bubbles, pinholes,
or
other
leakage. Never grasp a high pressure
hose that
is
leaking
or
damaged.
Never touch, grasp
or
attempt to cover a
pinhole
or
similar water leak on the high
pressure
hose.
The
stream
of
water IS
under high pressure
and
WILL
penetrate
sNn.
Never place hands in front
of
nozzle.
Direct spray away from self
and
others.
Make sure
hose
and
fittings are tightened
and in
good
condition. Never hold onto
the
hose
or
fittings during operation.
Do not allow hose to contact muffler.
Never attach
or
remove wand
or
hose
fittings while
system
is
pressurized.
When
using replacement lances
or
guns
with this pressure washer, DO
NOT
use
a lance and/or lance/gun combination
that
is
shorter in length than what
was
provided with this pressure washer
as
measured from the nozzle end
of
the
lance to the aun
triaaer.
Injuries can result
if
system
pressure
is
not
reduced before attempting
maintenance
or
disassembly.
To
relieve
system
pressure, shut
off
engine, tum
off
water supply and pull gun
trigger until water
stops flowing.
Use
only
accessories
rated equal to
or
higher than the rating
of
the pressure
washer.
4- ENG

Related product manuals