DRAFT
DRAFT
17
7 PROGRAMMING AND CONFIGURATION
Introduction
All Transmitting / Receiving characteristics of the H2 Series radio telephones
are stored in Non Volatile Memory (NVM). The NVM of any H2 Series radio can
be programmed with new characteristics using the programming kit, Part
Number XXXXX.
7.1 Configuration Settings. The following features are available:
COUNTRY Selects primary mode. NVMs with INT
(International) selected for the FIRST
COUNTRY flag will receive on the INT
Rx frequencies. The radio can be
switched to USA with weather
channels if the VOL key is depressed
on power up unless the SELECTED
MODE ONLY flag is set.
(SECOND MODE – YES).
SECOND MODE Enables or disables switch to USA with
weather channels.
SCANNING Enables and disables SCAN and
MEMORY SCAN functions.
CHANNEL 10 SCAN Enables or disables Channel 10 from
SCAN facility, (Scanning Channel 10 is
not permitted in some countries).
DUAL WATCH Enables or disables DUAL WATCH
TRI WATCH Enables or disables TRI WATCH
PRIORITY CHANNEL Selects alternate channel to be
monitored when DUAL WATCH
selected.
FIRST KEY BEEP Enables or disables KEY BEEP
STARTUP CHANNEL (SC) Selects channel to be displayed on
power up, usually Channel 16
WATCH CHANNEL (WC) Selects third channel to be monitored
when TRI WATCH selected.
USA / CANADA Enables or disables USA weather
WEATHER CHANNELS channels.
To Next Page
Loading...
Need help?
General
