How to fix a Simrad RD68 that will not switch on?
If your Simrad Radio unit won't switch on, it could be due to a faulty power connection. In this case, check the power connection. Alternatively, the fuse may have blown. If this is the case, replace the fuse and check the power supply current.
Why are Simrad RD68 transmissions weak and the display flashes ANT?
If transmissions are persistently weak and the display flashes 'ANT' on your Simrad Radio, it could be due to a damaged antenna. Try replacing the antenna. Another possible cause is a broken antenna cable, so replace the cable. Finally, it may be due to poor contact, so check the antenna sockets and through-deck connector.
What to do if Simrad RD68 Radio will not transmit on 25W but OK on 1W?
If your Simrad Radio will not transmit on 25W but is OK on 1W, it could be due to low voltage when the full transmitting current is drawn. Check the power supply. It may also be that some channels are restricted to low power transmission only, so consult your national authority.
Why is Simrad RD68 Scan locking on a channel without a signal?
If the Scan or Memory Scan function on your Simrad Radio is locking onto a channel without a signal, it may be due to noise on the channel holding the scan. To resolve this, increase the squelch level. Another option is to inhibit the channel from the scan.
Why is Dual Watch not working on Simrad Radio?
If Dual Watch is not being entered on your Simrad Radio, it could be because a priority channel is selected. Select a working channel. It could also be because the handset is off the cradle, so replace the handset.
Why are certain channels not obtainable on Simrad RD68?
If certain channels are not obtainable on your Simrad Radio, it may be because some channels are restricted and not programmed depending on the country of purchase. Consult your national authority for permitted channels in your region.
What to do if Simrad RD68 transmissions are weak and the display flashes ANT?
If you are experiencing weak transmissions and the display flashes 'ANT' on your Simrad Radio, it could be due to several reasons: * The antenna might be damaged, consider replacing it. * The antenna cable could be broken, in which case, replace the cable. * There might be poor contact in the antenna sockets or through-deck connector, so check these connections.
Why Simrad RD68 Radio will not transmit on 25W but is OK on 1W?
If your Simrad Radio transmits on 1W but not on 25W, there are a couple of possible causes: * There might be low voltage when the full transmitting current is drawn, so check the power supply. * Some channels are restricted to low power transmission only. Consult your national authority.
What to do if Simrad Radio scan is locking on a channel without a signal?
If the Scan or Memory Scan function on your Simrad Radio is locking onto a channel without a signal, the issue might be due to noise on the channel holding the scan. To resolve this, increase the squelch level. Another solution is to inhibit the channel from the scan.
What to do if Dual Watch is not being entered on Simrad Radio?
If Dual Watch is not being entered on your Simrad Radio, it could be due to these reasons: * A priority channel might be selected, so select a working channel. * The handset might be off the cradle, so replace the handset.
Procedure for programming the vessel's unique Maritime Mobile Service Identifier (MMSI).
Explanation of the RD68's operational modes, controls, and basic interface layout.
Setting transmit power levels and initiating Digital Selective Calling (DSC) calls.
Procedures for sending distress alerts and receiving DSC calls from other vessels.
Guidelines for physically mounting the VHF radio unit and ensuring proper placement.
To Next Page
General
