| 15
Operation | FU80, NF80, QS80 User Guide
Mode selection
You toggle between available modes by repeatedly pressing the
MODE key. The selection times out and triggers the mode shift.
When in any other mode than NFU, the first press on the MODE
key will turn the system to NFU mode.
You switch to Standby from any mode by pressing the STBY key.
Non-follow up steering
In this mode you use the lever to move the rudder. The rudder will
move in the same direction as the lever, and will move as long as
the lever is moved from mid-position.
¼ Note: See “Changing commanded rudder direction” on page 20.
Auto and NoDrift mode
When you select AUTO/NoDrift mode, the system will continue on
the heading/course read from the sensors the very moment you
selected the mode.
Auto mode NoDrift mode
Changing set heading/set course
Use the lever to change set heading in AUTO mode and set
course in NoDrift mode. The value will change 1° each time the
lever is pressed to left or right. If you keep the lever pressed, the
value automatically changes at a rate of 5° per second. Each beep
indicates a 1° change.
To Next Page
Loading...