Simrad QS80 - Changing Default Settings; Navigating the Main Menu

22 |
Changing default settings | FU80, NF80, QS80 User Guide
Changing default settings
The main menu
The default settings can be changed from the Main menu, activated
by pressing and holding the MODE key for 3 seconds.
Local settings
Simnet groups
Language
Key beeps
Local reset
Alarm buzzer
Display
Invert lever *
About
Backlight
Units
Damping
Station
Alarms
Sources
Day mode
Night mode
Red backlight
Inverse display
Contrast
Red backlight
Inverse display
Contrast
LEVEL 1 LEVEL 2 LEVEL 3 LEVEL 4
* Only available on FU80 and NF80.
• Local settings: Gives access to settings that applies to this unit
• SimNet group: Assigns this unit to a SimNet group
You remove the menu and return to standard display by pressing
and holding the STBY key, or by moving the lever/stick.
¼ Note: The main menu is only accessible from Standby mode.
4