Simu SMC - Page 3

JP3
JP4
JP1JP1
NC
NO
MOMMOM
CONTCONT
JP1JP1
NC
NO
MOMMOM
CONTCONT
STOP SELECT JUMPER JP1 (BOTTOM)
JUMPER ON (N.O.)
WITH THE JUMPER ON, THE STOP BUTTON IS SELECTED
NORMALLY OPEN (N.O.). A CLOSED STOP CONTACT
WILL STOP THE MOTOR AND LIGHT THE YELLOW STOP
LED.
NOTES:
1) THE JUMPER MUST BE IN THIS POSITION IF A STOP
SWITCH IS NOT USED OR IF THE STOP BUTTON IS N.O.
JUMPER OFF (N.C.)
WITH THE JUMPER OFF, THE STOP BUTTON IS SELECTED
NORMALLY CLOSE (N.C.). A OPEN STOP CONTACT
WILL STOP THE MOTOR AND LIGHT THE YELLOW STOP
LED
NOTES:
1) THE JUMPER MUST BE IN THIS POSITION IF A N.C.
STOP SWITCH IS USED. LEAVING THE JUMPER ON
WITHOUT A N.C. STOP BUTTON ATTACHED WILL CAUSE
THE SMC TO NOT OPERATE.
REVERSING DETECTOR JUMPERS (JP3 JP4)
JP3
JP4
JUMPERS OFF (4 WIRE EDGE)
BOTH JUMPERS JP3 AND JP4 MUST BE OFF TO USE A
4 WIRE SENSING EDGE.
NOTES:
1) IF EITHER JUMPER IS OFF WITHOUT A 4 WIRE
SENSING EDGE ATTACHED, THE RED SAFETY LED WILL
LIGHT AND THE DOOR WILL BE LOCKED IN THE UP
DIRECTION.
BOTH JUMPERS JP3 AND JP4 SHOULD BE ON IF A
NORMALLY OPEN REVERSING SENSOR IS USED OR
IF NO REVERSING SENSOR IS USED.
NOTES:
1) IT IS STRONGLY RECOMMENDED THAT A REVERSING
SENSOR BE USED IF THE SMC RUN TIMER IS ON.
JP3
JP4
JUMPERS ON
(2 WIRE EDGE OR N.O. DETECTOR)
1 JUMPER ON, 1 JUMPER OFF
(N.C. DETECTOR)
WITH JUMPER JP3 ON AND JP4 OFF A NORMALLY
CLOSE REVERSING SENSOR CAN BE CONNECTED TO
SE1.
NOTES:
1) WITH JP4 OFF A NORMALLY CLOSE CONTACT
MUST BE CONNECTED TO SE1 OR THE SMC WILL
LOCK THE DOOR OPEN.
INSTALLERS MANUAL
PAGE: 2 OF 5