Simu T5E-SP Hz - Wiring; Compatible Transmitters

End-limit adjustement
4
Compatible transmitters
3
Wiring
2
2/6
1
2
4
3
T6E-SP Hz
2
3
5
4
STEEL
T5E-SP Hz : 9910004
T6E-SP Hz : 9910062
Nm ≥ 60 & ALUMINIUM WHEEL
PE
L
N
230V~50Hz
T5E-SP Hz / T6E-SP Hz
Blue
Brown
Green / yellow
You must have the possibility to switch o󰀨
individually each motor.
- Attach cables to prevent any contact with moving
parts.
- If the motor is used outdoors and if the power
supply cable is of the H05-VVF type, then run the
cable in a UV-resistant conduit, e.g. trunking.
(12 transmitters max./3 sensors max. for one motor)
1: 1/5 channels Wall Hz transmitters / Memory Hz
2: 1/5 channels / SUN Mobile Hz transmitters
3: Color Multi 16 / Timer Easy / Timer Multi transmitters
4: Windy Hz Accel
5: EOSUN Hz VS
Location of the PROG key on Hz transmitters:
Do not position the transmitter near metal in order to
avoid range losses.
If the installation includes several motors, only one motor is to be powered during this programming proce-
dure (4.1). It will eliminate interferences with the other motor during the procedure.
4.1- Learning mode:
- Switch the motor ON.
- Simultaneously press the “Up” and “Down” buttons of a Hz
transmitter. The motor will run for 0,5 second in one direction,
then in the other. The transmitter now controls the motor in
unstable mode, move to stage 4.2
4.2- Checking the rotation direction :
>>
ON
3s
a
OK 4.3
OK 4.3
b
>>
>>
>>
>>
>>
>> >>
Press the “Up” button of the transmitter:
a- If the motorized tube runs in the up direction, move to next stage (4.3).
b- If the motorized tube runs in the down direction, reverse the rotation direction by pressing the “Stop” button for at
least 3 seconds. The motor will run for 0,5 second in one direction, then in the other direction. Move to the stage 4.3.
2 3
3
4
4
5
5
1