DC INVERTER U-MATCH AIR CONDITION MAINTENANCE
146
3. Remove the front panel
●Firstly, use screwdriver
to remove the screws on
the four sides of the front
panel.
●Remove the front panel
from the unit.
4. Remove the side plate
●Firstly, use screwdriver
to remove the screws on
the four sides of the side
plate.●Remove the side
plate from the unit.
Disassembly and Assembly of Compressor
Remark : Make sure there isn’t any refrigerant in pipe system and the power supply is cut off
before removal of the compressor..
Step Illustration Handling Instruction
1.Disconnect the electrical
source wire
●Relax the screws with the
screwdriver.
●Draw out the electrical
source wire
Note:Earmark the colour of
wire corresponding to the
terminal when Removing the
wire , the mistakes can be
avoided when renewing the
wire connection.
2. Remove the nuts fixing the
compressor
●Firstly, use spanner to
remove the bolts fixing the
compressor.
Disconnect the
electrical
source wire of
compressor
To Next Page
Loading...
