DC INVERTER U-MATCH AIR CONDITION MAINTENANCE
180
loosened)
Removal of Drainage Pump
Remark: Before removal, please make sure that the power supply has been cut off. During removal, please
protect the parts properly.
Step Illustration Handling Instruction
1. Remove the
screws fixing
the side
seal-hole plate
and drainage
pipe.
● Loosen the screws
fixing the side seal-hole
plate and water pump
drainage pipe. Then,
remove the seal-hole
plate. (As shown, what
the circle indicates are
the screws fixing the
seal-hole plate and what
the square indicates are
the screws fixing the
drainage pipe. There are
8 screws in total to be
loosened).
2. Remove the
screws fixing
the drainage
pipe
● Remove the screws
fixing the drainage
pump. (As shown, what
the circle indicates is the
screw)
3. Remove the
condensate
drainage pump
● The condensate
drainage pump after
removal is as shown on
left.
To Next Page
Loading...
