DC INVERTER U-MATCH AIR CONDITION MAINTENANCE
182
2. Remove the
motor
● Loosen the screws
fixing the fan and
motor. Remove the
motor. (The screws as
shown by the square
in Fig. 11)
Removal of Evaporator
Remark: Before removal, please make sure that the power supply has been cut off. During removal, please
take care to protect the copper tube and aluminum fin of evaporator. The copper tube shall be well sealed if
it is to be removed for a long time.
Step Illustration Handling Instruction
1. Remove the
screws fixing
the evaporator
side board.
● Loosen and remove
the screws fixing the
left / right side board
and top cover board of
the evaporator (in a
direction as shown by
the arrow in Fig. 12).
2. Remove the
screws fixing
the evaporator
valve seal-hole
board and joint
flange.
● Loosen the screws
fixing the valve
seal-hole board and
remove the valve
seal-hole board.
Loosen the screws
fixing the joint flange of
evaporator (As shown,
the screws inside the
sqaure are for fixing the
seal-hole board and
those indicated by the
circle are for fixing the
joint flange).
3. Remove the
evaporator
● Remove the
evaporator. The
evaporator after
removal is as shown on
left.
To Next Page
Loading...
