DC INVERTER U-MATCH AIR CONDITION MAINTENANCE
184
4.2.2 Ceiling Type
Removal of Front Grill Sub-assembly
Remark: Before removal, please make sure that the power supply has been cut off. During removal, please
protect the parts properly and do not put the filter close to the source of high-temperature heat.
Step Illustration Handling Instruction
Removal of Front
Grill
Sub-assembly
● Use your hand to
move the clamp of
front grill
sub-assembly
downward, until the
front grill is opened.
(The clamp position
is as shown by the
arrow. Each grill has
two clamps)
Removal of Left / Right Decorative Plate
Remark: Before removal, please make sure that the power supply has been cut off. During
removal, please protect the parts properly. Take special care not to scratch the surface parts
Step Illustration Handling Instruction
Removal of
Left / Right
Decorative
Plate
●Disassemble the
screws as shown in
the graph with
screwdriver and then
push upward to
remove the right and
left finishing
plates.(As is shown
in the graph, arrow
represents the
position of screws.)
To Next Page
Loading...
