SLEEP button
16
●
Pressing this button can select Sleep 1, Sleep 2,Sleep 3, Sleep 4 or cancel Sleep
circularly as below:
cancel
Introduction for buttons on remote controller
12
Humdity/health button
Press this button to select your required operation mode.
Note:there is no this function for this unit. If press this button,the main unit will click,
but it also runs under original status.
INTELLIGENT INTELLIGENT
Press this button to select your required operation mode.
Note:there is no this function for this unit. If press this button,the main unit will click,
but it also runs under original status.
cancel
cancel
X-FAN button
13
Pressing this button in COOL or DRY mode, the icon " " is displayed and the
indoor fan will continue operation for 2 minutes in order to dry the indoor unit even
though you have turned off the unit. After energization, X-FAN OFF is defaulted.
X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor unit will be blowed
after the unit is stopped to avoid mould.
● Having set X-FAN function on: After turning off the unit by pressing ON/OFF
button indoor fan will continue running for about 2 min. at low speed. In this
period, press X-FAN button to stop indoor fan directly.
● Having set X-FAN function off: After turning off the unit by pressing ON/OFF
button, the complete unit will be off directly.
14
Air button
LIGHT button
15
Pressing this button to turn off display light on indoor unit. Press this button again
to turn on display light.
To Next Page
Loading...
Need help?
General
