Press "+" and "-" buttons simultaneously to lock or
unlock the keypad. If the remote controller is locked,
Combination of "+" and "-" buttons:
is displayed. In this case, pressing any button,
blinks three times.
about child lock
Function introduction for
combination buttons
At unit OFF, press "Mode" and "-" buttons simultane-
ously to switch between °C and °F.
Combination of "Mode" and "-" buttons:
About switch between Fahrenheit and centigrade
Combination of "Temp" and "Clock" buttons:
About Energy-saving Function
Press "Temp" and "Clock" simultaneously in Cool
mode to start energy-saving function. Nixie tube on
the remote controller displays "SE". Repeat the oper-
ation to quit the function.
Combination of "Temp" and "Clock" buttons:
About 8°C Heating Function
About Health function (COLD PLASMA)
Turn on the unit, start up the fan (Breezing and
X-FAN are excluded) and press Health button on
remote controller to start health function (If there is
not Health button on remote controller, the unit
defaults health function ON. )
Press "Temp" and "Clock" simultaneously in Heat
mode to start 8°C Heating Function Nixie tube on the
remote controller displays " " and a selected
temperature of "8°C" (46°F if Fahrenheit is adopted).
Repeat the operation to quit the function.
●
●
●
●
●
●
Replacement of batteries in
remote controller
During operation, point the remote control signal
sender at the receiving window on indoor unit.
The distance between signal sender and receiving
window should be no more than 8m, and there
should be no obstacles between them.
Signal may be interfered easily in the room where
there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit
during operation.
Replace new batteries of the same model when
replacement is required.
When you don
'
t use remote controller for a long time,
please take out the batteries.
If the display on remote controller is fuzzy or there
'
s
no display, please replace batteries.
Press the back side of remote controller
marked with " ", as shown in the fig, and then
push out the cover of battery box along the
arrow direction.
Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
Reinstall the cover of battery box.
2.
1.
3.
battery
Cover of battery box
remove
reinstall
button
Wi Fi
●
This function is only available for some models.
Press "WiFi" button to turn on WiFi function, "WiFi"
icon will be displayed on the remote controller;
Hold "WiFi" button for 5s to turn off WiFi function
and "WiFi" icon will disappear.
Under off status, press "MODE" and "WiFi" buttons
simultaneously for 1s, WiFi module
will restore
factory settings.
NOTICE
To Next Page
Loading...
Need help?
General
