3.
●
The power cord and control wire can't be crossed or
●
The drain hose should be bound at the bottom.
1. Put the bound pipes in the wall pipe and then
●
The wiring board is for reference only, please refer
5. Check if the indoor unit is installed firmly and
upper hook
indoor unit
band
●
lower hook of
wall-mounting frame
2.
NOTICE
winding.
Hang the indoor unit
3.
4.
closed to the wall.
Step 9:
indoor
wall pipe
4.
2.
NOTICE
3.
outdoor
4.
sealing gum
5.
gas
pipe
Step 8:
Bind up pipe
1.
liquid pipe
drain hose
indoor and
outdoor power cord
NOTICE
to the actual one.
Do not bend the drain hose too excessively in order
to prevent blocking.
drain hose with the band.
connection pipe
drain hose
band
indoor power cord
Bind up the connection pipe, power cord and
Bind them evenly.
The liquid pipe and gas pipe should be bo-
und separately at the end.
Put wiring cover back and then tighten the screw.
Close the panel.
Reserve a certain length of drain hose and
power cord for installation when binding th-
em. When binding to a certain degree, sep-
arate the indoor power and then separate
the drain hose.
Outdoor unit connection
3
N(1)
2
green
blue
brownblack
yellow-
Outdoor unit connection
N(1)
2 3
yellow-
green
blue black brown
make them pass through the wall hole.
Hang the indoor unit on the wall-mounting
frame.
Stuff the gap between pipes and wall hole
with sealing gum.
Fix the wall pipe.
Remove the wire clip; connect the
power conn-
ection wire to the wiring terminal according to
the
color; tighten the screw
and
then fix the po-
wer
connection
wire
with wire clip.
SIH-09BIK
SIH-12/18/24BIK
To Next Page
Loading...
Need help?
General
