Need help?Do you have a question about the Sincro RD1 and is the answer not in the manual?
General| Brand | Sincro |
|---|---|
| Model | RD1 |
| Category | Controller |
| Language | English |
Adjusts output voltage using the 'V' trimmer; ranges are dependent on DIP switch settings for voltage sensing.
Modulates reaction time via 'ST' potentiometer to eliminate instability in the alternator-load system.
Describes the UF circuit providing volts/Hz characteristic below a settable speed threshold for protection.
Periodical inspections for cleanliness, dust, moisture, and terminal corrosion to ensure equipment longevity.
Lists common issues like no/low/high voltage, instability, or fuse blows, with causes and solutions.
To Next Page
