To Next PageTo Next PageWhat to do if there's fault wiring or a short circuit in the Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve fault wiring or short circuits.
What to do if the weight of the bowl or chute is too heavy for the Sinfonia Technology Controller drive unit?
If the bowl or chute is too heavy, reduce the weight by decreasing the thickness of the bowl or chute. You may also need to adjust the air gap.
What to do if there is fault wiring, confusing polarities, or the air gap is out of standard width in the Sinfonia Technology Controller?
Review the wiring plug connector. Additionally, narrow the air gap of the core and armature of the drive unit.
How to adjust the resonant frequency of the Sinfonia Technology Controller?
Review the function setting. Readjust the resonant frequency of the drive unit with leaf springs.
Why is the drive frequency range out of the resonant frequency of the drive unit in Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve this problem.
What to do if there is a fault function setting for the Stroke Sensor of Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve this problem.
What to do if the feeder provides a bowl out of the specification for Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve this problem.
General| Manufacturer | Sinfonia Technology |
|---|---|
| Model | C10-1VFEF |
| Category | Controller |
| Installation | Wall mounting |
| Enclosure Rating | IP20 |
| Input Frequency | 50/60 Hz |
| Output Frequency | 0-400 Hz |
| Overload Capacity | 150% for 60 seconds |
| Protection Functions | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit |
| Vibration Resistance | 5.9 m/s² (0.6G) max |
Provides initial guidance on essential safety instructions and classifications.
Details of danger, warning, caution, and request classifications and associated safety measures.
Explanation of buttons, lamps, and dials on the control panel.
Procedure for starting and stopping the partsfeeder using the control panel.
Step-by-step guide for initial parameter adjustments like Stroke and Frequency.
Configuring the appropriate output frequency range for the partsfeeder.
Setting the stroke parameter using the auto-tuning mode for optimal performance.
Guides to identify and resolve common operational issues.
Explanation of error codes and procedures for correction.
