To Next PageTo Next PageWhat to do if there's fault wiring or a short circuit in the Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve fault wiring or short circuits.
What to do if the weight of the bowl or chute is too heavy for the Sinfonia Technology Controller drive unit?
If the bowl or chute is too heavy, reduce the weight by decreasing the thickness of the bowl or chute. You may also need to adjust the air gap.
What to do if there is fault wiring, confusing polarities, or the air gap is out of standard width in the Sinfonia Technology Controller?
Review the wiring plug connector. Additionally, narrow the air gap of the core and armature of the drive unit.
How to adjust the resonant frequency of the Sinfonia Technology Controller?
Review the function setting. Readjust the resonant frequency of the drive unit with leaf springs.
Why is the drive frequency range out of the resonant frequency of the drive unit in Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve this problem.
What to do if there is a fault function setting for the Stroke Sensor of Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve this problem.
What to do if the feeder provides a bowl out of the specification for Sinfonia Technology Controller?
Unfortunately, there is no specific solution provided in this manual extract to resolve this problem.
Crucial safety information to be read thoroughly before operating the controller.
Diagnostic guide for common problems and their solutions.
Connecting power supply, output cables, and stroke sensor.
Instructions for starting and stopping the partsfeeder using the panel.
Step-by-step guide for initial setup of the controller.
Procedure for adjusting specific function set values.
Guide to setting the appropriate output frequency range.
Setting the stroke parameter in auto-tuning mode.
Wiring instructions for overflow and stroke sensors.
Crucial safety information to be read thoroughly before operating the controller.
Diagnostic guide for common problems and their solutions.
Connecting power supply, output cables, and stroke sensor.
Instructions for starting and stopping the partsfeeder using the panel.
Step-by-step guide for initial setup of the controller.
Procedure for adjusting specific function set values.
Guide to setting the appropriate output frequency range.
Setting the stroke parameter in auto-tuning mode.
Wiring instructions for overflow and stroke sensors.
General| Brand | Sinfonia Technology |
|---|---|
| Model | C10-5VFEF |
| Category | Controller |
| Language | English |
