Manual for SINGCALL Receivers
SINGCALL Receiver
Operating Instructions
◆Number registration (Not suitable for APE8800)
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Press the key [ENT] till [01] [001] or [001-01] appears.
3) Press the key [UP], [[MOVE]] or [DOWN] to choose the registration number you wanted.
4) Press the call pager, waiting for the number flashes on the screen with sound signals.
5) Press the key [ESC], and [F1] appears.
6) Press the key [ESC] again, back to standby mode. The registration is finished.
7) Repeat step 3）~4）to register all the call pagers you need, and then press the key [ESC] twice
back to standby mode.
◆Sound setting
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Use the key [UP] to choose [F2].
3) Press the key [ENT] and [01] or [12] appears.
4) Use the key [UP], [DOWN] to choose a type of sound (“00”-“11” are 12 kinds of beautiful music;
“12” is voice reporting).
** Only APE1000 series and APE2000 series have voice reporting function.
5) Press the key [ENT], and [F2] appears
6) Press the key [ESC] again and back to standby mode.
◆Calling display number time setting
1) Standby mode, press the key [FUN] for 3 seconds till [F1] appears on the screen.
2) Use the key [UP] to choose [F3].
3) Press the key [ENT], and [20] or [0000](for APE8800) appears on the screen.
4) Use the key [UP], [DOWN] to choose the display time wanted. [00] or [0000] (for APE8800)
means unlimited display, figures “01”-“99” mean the corresponding time from 1~ 99 or 9999 (for
APE8800) seconds.
To Next Page
Need help?
General
