Singer Instruments ROTOR HDA - Page 19

19
singerinstruments.com
software icon guiDe
ICON NAME SETTING DESCRIPTION TAB UNIT MIN MAX DEFAULT
Manual
Fixed
Source
Pinning
Pressure
Source
Pinning
Speed
Agar
Agar
Agar
Source
Pinning
Backoff
Liquid
Liquid
Liquid
Dry Mix
Source
Dry Mix
Clearance
Dry Mix
Diameter
Dry Mix
Cycles
Source
Pinning
Overshoot
Offset
Offset
Repeat
Source
Pinning
Source
Pinning
Speed
Repeat
Source
Pinning
On/Off
Select a manual offset before each
source pinning.
A pre-specified fixed offset is used for
selected source pins.
The pressure that the Pad Head will use
to push onto the agar.
The speed that the Pad Head will use to
connect to the agar surface.
The number of times each source pin-
ning will repeat.
The speed applied to pinning to wet
source plates.
The retraction distance applied to the
Pad Head after sensing the bottom of
the plate.
The number of times each source pin-
ning will repeat.
Skipping around on the agar surface to
select from a wider area of cells.
The distance the pins retract from the
agar surface.
The diameter of the mix.
The number of cycles (comprising of 5
steps) that the dry mix on source plates
will be executed.
The amount of travel that will be ap-
plied after detecting agar contact. This
is to enable operation of the pressure
cylinder.
Boolean
Boolean
%
mm/s
Integer
mm/s
mm
Integer
Boolean
mm
mm
Integer
mm
Off
Off
0
1
1
1
-0.5
1
Off
0
0.1
1
On
On
100
20
10
19
3
10
On
4
2
10
Off
Off
Varies for
each pad
19
1
19
0.5
1
Off
0.5
1
1
2
Source>Offset
Source>Offset
Source>Pinning
Source>Pinning
Source>Pinning
Source>Pinning
Source>Pinning
Source>Pinning
Source>Dry Mix
Source>Dry Mix
Source>Dry Mix
Source>Dry Mix
Source>Pinning
Speed
dependant
Speed
dependant