Need help?Do you have a question about the Singer 107W1 and is the answer not in the manual?
General| Brand | Singer |
|---|---|
| Model | 107W1 |
| Category | Sewing Machine |
| Language | English |
Intended for overseaming and zigzag stitching at high speed on various fabrics and light leather.
Designed for basting and tacking coat pads, offering rapid and satisfactory work.
For hemming shades, features a rotary hook with a large bobbin and high-speed zigzag lock stitch.
Information on buying parts, needles, and recommended operating speeds for the machines.
Details needle classes, varieties, and sizes for Machines 107w1, 107w3, and 107w5.
Table showing recommended needle sizes for cotton and silk thread for different cloth work.
Specifies thread types and advice for needle and bobbin use, recommending soft finish thread.
Guidance on oiling machine parts and explanation of the oil conduits system for lubrication.
Instructions on how to properly insert and secure the needle in the needle bar.
Step-by-step guide on how to thread the sewing machine from spool to needle.
Explains how to adjust the feed regulator to set the number of stitches per inch.
Instructions for removing, threading, and replacing the bobbin case.
How to adjust upper and bobbin case tensions for proper stitch formation.
Step-by-step instructions for preparing, winding, and adjusting bobbin winding.
Detailed steps to begin sewing, including initial threading and material placement.
Advice on common sewing issues like pulling work or improper feed/pressure.
Instructions on how to turn the work while sewing, using the needle as a pivot.
Steps to safely remove the sewn material from the machine.
Addresses issues like tension, lint, needle, or thread problems.
How to adjust the width of the zigzag stitch for different sewing needs.
Explains the function of the thread controller spring and how to adjust its action.
Instructions for adjusting the feed mechanism for proper stitch formation.
Procedures for timing and adjusting the needle bar for correct stitch formation.
Procedures for verifying and setting the needle bar's position and timing.
Fine-tuning the feed regulator for precise stitch length control.
Adjusting the width of the zigzag stitch for different sewing needs.
Procedures for removing and replacing the needle vibrator gear shaft and arm shaft.
Checking, timing, adjusting, and removing the hook mechanism.
Instructions for removing the belt and the arm shaft bushing.
To Next Page
