APRON
CENTER SLOT ,
ADJUSTING
SCREW
OUTSIDE
SLOT OF
SCROLL
BINDER
SCROLL
FIG. 39
Fla. 40
CUTTING POINT
ON BINDING
42
Attaching the Binder to the Machine
Raise the needle to its highest position and remove
the presser foot from the machine by loosening the
thumb screw which holds it in place. Compare the
foot of the Binder and the presser foot and you will
see that they are attached to the machine in the
same manner. Attach the Binder to the presser bar.
Turn the balance wheel slowly
toward you to make sure that the
Binder is properly attached to the
bar and that the needle goes through
the center of the needle hole.
Inserting the Binding in
the Binder
Cut the binding to a long point
to left, as shown. Insert the pointed
end in the binder scroll (Fig. 41)
until the pointed end comes
through the lower end of the scroll.
42
Attaching
the
Binder
to the
Machine
Raise
the
needle
to
its highest position
and
remove
the presser
foot
from
the
machine
by
loosening
the
APRON-
CENTER
SLOT-^-
tJ3595
FIG.
39
thumb screw which holds
it in
place. Compare
the
foot of the
Binder
and the
presser
foot and you
will
see that they
are
attached
to the
machine
in the
same manner. Attach
the
Binder
to the
presser
bar.
Turn
the
balance wheel slowly
toward
you to
make sure that
the
Binder
is
properly attached
to the
bar
and that the needle
goes
through
the center
of the
needle hole.
Inserting
the
Binding
in
the
Binder
Cut
the
binding
to a
long point
to left,
as
shown.
Insert
the
pointed
end
in the
binder scroll
(Fig. 41)
until
the
pointed
end
comes
CUTTING
POINT
through
the
lower
end of the
scroll.
ON
BINDING
To Next Page
Loading...
