Singer 263 - Changing Presser Feet

2. Getting Ready
toSew
Choosing and
Changing Accessories
CAUTION* Disconnect the power line plug
from the socket outlet when changing needles,
feet, or needle plates, or when leaving the
machine unattended. This eliminates the
possibility of starting the machine by
accidentally pressing the speed controller.
Changing Presser Feet
• Raise needle to highest position by turning
the hand wheel toward you.
• Raise presser foot.
1. Press toe of presser foot upward as far as
it wii) go until it snaps free.
2. Centre the new presser foot under the
shank A. Lower the presser foot lifter so
that the shank fits over the presser foot
pin.
3. Press presser foot screw down firmly until
foot snaps into place.
J K