• Keep fingers away from all moving parts. Special care is
required around the sewing machine needle.
• Always use the proper needle plate. The wrong plate can
cause the needle to break.
• Do not use bent needles.
• Do not pull or push fabric while stitching. It may deect the
needle causing it to break.
• Wear safety glasses.
• Switch the sewing machine off (“0”) when making any
adjustment in the needle area, such as threading needle,
changing needle, threading bobbin, or changing presser
foot, etc.
• Never drop or insert any object into any opening.
• Do not use outdoors.
• Do not operate where aerosol (spray) products are being
used or where oxygen is being administrated.
• To disconnect, turn all controls to the o (“0”) position, then
remove plug from outlet.
• Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
• The foot control is used to operate the machine. Avoid
placing other objects on the foot control.
• Do not use the machine if it is wet.
• If the LED lamp is damaged or broken, it must be replaced
by the manufacturer or its service agent or a similarly
qualied person, in order to avoid a hazard.
• If the supply cord connected with the foot control is
damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person, in order to
avoid a hazard.
• This sewing machine is provided with double insulation.
Use only identical replacement parts. See instructions for
Servicing of Double-Insulated Appliances.
Eng 2
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
