Singer ES110 - Before Using For The First Time; Initial Setup and Flushing; Machine Preparation Steps; Preheating The Espresso Machine

7
ENGLISH
Before using for the fi rst time
1. Remove all packaging.
2. Wind excess cable around the storage slot on the bottom of the machine.
3. Wash the parts; please refer to “Cleaning”.
4. Flush the machine thoroughly with clean water in the following steps:
a) Make sure all the buttons are in the off position and that the steam/hot water knob is
closed by turning clockwise.
b) Lift out the tank, draw up the lid and fi ll with cold water up to the MAX level marked.
Alternatively draw up the lid and fi ll the tank whilst in position on the espresso machine.
We recommend using fi ltered water as it produces better coffee and reduces lime scale,
never use fi zzy water.
c) Refi t the tank, make sure that it is correctly located and apply light pressure if necessary
to ensure the valve at the bottom of the tank connects with the water inlet of the machine.
It is normal for water to remain in the compartment under the tank; this can be done using a
sponge.
d) Swing out the steam/hot water nozzle then attach the fi lter holder to the machine by
positioning it under the boiler outlet and turning to the right, place a bowl underneath.
e) Plug in the mains supply, Press down the On/Off button then the power light will glow.
f) Immediately press down the coffee/hot water button and wait until water drip from the fi lter
holder. This means the boiler has been fi lled with water.
Note: You have to operate this step as soon as possible; otherwise the boiler will be dry-boiled.
Important: You can not brew espresso if you have not fl ushed the machine at fi rst, the fl ushing
cycle causes the boiler to fi ll with water. If you have not used the machine for a few days, you
have to fl ush it with fresh water before you use it again.
Preheating the espresso machine
To ensure your espresso coffee is brewed at the right temperature it is essential that the coffee
appliance is preheated.
1. Check that the steam/hot water knob is fi rmly closed (turn clockwise) and that there is water
in the tank.
2. Put a jug under the steam/hot water nozzle.
3. Fit the desired fi lter into the fi lter holder (without coffee) and attach to the machine by
positioning it under the boiler outlet and turning to the right, ensure is it fi rmly located.
4. Position two cups under the fi lter holder; if you use the same cup that the coffee will be
served in it will be preheated. Alternatively the cups can be preheated on the cups warming
tray.
5. Press the On/Off button and wait until the ready light glows.
6. Press down the coffee/hot water button and wait until two cups of water runs into the bowl.
7. Turn the steam/hot water knob anti-clockwise and allow a little amount of water to run into
the jug.