Inserting the bobbin
Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
1 Thread
2 Bobbin holder
Guide the thread into the notch on the front of
the bobbin holder.
3 Notch on the front.
Draw the thread to the left, sliding it between
the tension spring blades
4 Spring blades
Continue to draw the thread lightly until the
thread slips into the notch on the side.
5 Notch on the side
Pull out about 10 cm (4'') of thread to the rear.
Reattach the bobbin cover plate.
6 Thread
7 Bobbin cover plate
7
To Next Page
Loading...
