1
Thread through the hole in the bobbin from the
inside to the outside.
Put the bobbin on the bobbin winder spindle.
2 Bobbin winder spindle
Push the bobbin to the right.
With the free end of the thread held in your
hand,depress the foot switch.
After the bobbin has wound for about 10
seconds, stop the machine and cut the thread
close to the hole in the bobbin.
Depress the foot switch agian.
When the bobbin is fully wound, it stops
automatically.
Return the bobbin winder to its original position
by moving the spindle to the left, and cut the
thread.
WARNING:
The needle and take-up lever move up and
down while winding the bobbin.
Keep fingers away from all moving parts.
Special care is required around the sewing
machine needle.
To avoid possible injury, do not touch any
moving parts.
6
2
Draw the thread from the spool.
Pass the thread clockwise in front of the bobbin
winding tension disk, then bring the end of the
thread toward the right. Make sure the thread is
snuggly under the bobbin winding tension disk.
Bobbin Winding Tension Disk
2
To Next Page
Loading...
