Singer M1250 - Threading the Machine; Bringing Up Bobbin Thread

B
A
F
C
D
E
G
English
10
Important! Make sure that the presser foot is raised and the
needle is in its highest position by turning the handwheel
toward you. This is very important to help ensure that the
machine is correctly threaded. Not doing so can result in poor
stitch quality when you start to sew.
1. Pull up the spool pin to its full extent.
2. Place a thread spool on the spool pin.
3. Place the thread into the thread guide (A) from back to the
front. Make sure the threads slips into the spring (B).
4. Pull the thread over the thread guide (C) and down in the
threading slot (D).
5. Continue bringing the thread down through the right thread-
ing slot, around the the tension dial (E) (make sure the
thread slips into the tension discs). Then bring the thread
back upwards through the left threading slot.
6. Bring the thread from the right into the take-up lever (F)
and down in the left-hand threading slot, and into the needle
thread guide (G).
7. Thread the needle from front to back.
Thread the Machine
Machine from above
Machine from front
Bring Up the Bobbin Thread
1. Hold the upper thread with the left hand. Turn the hand
wheel towards you lowering, then raising needle.
2. If it is dicult to raise the bobbin thread, check to make
sure the thread is not trapped in the bobbin cover.
3. Gently pull on the upper thread to bring the bobbin thread
up through the needle plate hole.
4. Lay both threads to the back under the presser foot. Pull out
about 6–8” (15–20cm) of thread behind the needle.