1
2
A
B
English
8
Free Arm/Removable Accessory Tray
Presser Foot Lifter
Thread Knife
Store presser feet, bobbins, needles and other accessories in the
accessory tray so that they are easily accessible.
Keep the accessory tray on the machine to provide a larger, at
work surface.
Use the free arm to facilitate sewing trouser legs and sleeve
hems. To use the free arm, slide o the accessory tray. When
attached, a hook keeps the accessory tray securely attached to
the machine. Remove the tray by sliding it to the left.
The presser foot lever is located at the side of the sewing
machine head. The lever is used to raise and lower the presser
foot. Raise the lever up for machine threading, lower it for
sewing.
When the foot is in the raised position, press the lever further
upward for more room under the presser foot. This is good for
sewing thick projects.
To use the thread knife, pull the thread from back to front as
illustrated. Doing this will leave the thread ends long enough
so that the needle doesn't become unthreaded when you start to
sew again.
1. Make sure that the needle is in the highest position and the
presser foot is lifted. Pull the presser foot down and towards
you.
2. To attach a presser foot to the holder, line up the cross pin
on the foot (A) with the gap in the presser foot ankle (B).
Push the foot into the gap until the foot snaps into place.
Change the Presser Foot
To Next Page
Loading...
