Singer momento - Camera Calibration Guide for Right Tool Holder

22
Camera Calibration Guide for Right Tool Holder
Before you begin the calibration, make
sure to gather the following items:
Items Needed for Calibration:
• Pen and Pen Adaptor (both included
with the machine)
• Cardstock
• Mat
Instructions:
1. Power on your machine and allow it to
initialize.
2. Place the cardstock on the mat, en-
suring proper alignment, and gently
press it under the pinchwheels to
secure it in place.
3. Press the “Load Mat” button to load
the mat into the machine.
4. Take the pen adaptor and attach the
pen securely into it. Now, load the pen
with the adaptor into the right tool
holder of the machine.
5. Tap the settings button on the ma-
chine’s interface and select the
“Camera” option.
6. In the camera settings, choose “Ad-
just” to access the calibration screen.
7. Once in the calibration screen,
choose “Adjt R” to initiate the calibra-
tion process for the right pen.
8. The machine will automatically draw
a “田” symbol on the cardstock. Allow
the machine to nish the drawing.
9. Aer the drawing is completed, touch
the middle position of the + symbol on
the captured image displayed on the
screen. This will create a red + close
to the center position of the + symbol.
Conrm by tapping “OK.”
10. The machine will automatically
generate a blue dashed line to coin-
cide with the + symbol in the captured
image. Verify the alignment, and
when satised, press “RET” to save the
calibration parameters.