This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
To satisfy radio frequency exposure requirements, a separation distance of 8” (20
cm) or more should be maintained between this device and persons during device
operation. To ensure compliance, operations at closer than this distance is not
recommended. The built-in antenna used for this transmitter must not be co-located
in conjunction with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the authorized SINGER® retailer or an experienced radio/TV technician for
help.
The included interface cable should be used in order to ensure compliance with the
limits for a Class B digital device.
Any changes or modications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
Federal Communication Commission Interference Statement
For the USA and Canada
Responsible party: Singer Sourcing Limited LLC
1714 Heil Quaker Boulevard, Suite 130, LaVergne, TN
37086
Product name: Singer Momento 24" Cra Cutting Machine
To Next Page
Loading...