• Do not use bent cutting blades.
• Wear safety glasses.
• Switch the machine o (“0”) when
making any adjustment in the cutting
area, such as changing the cutting
blades.
• Do not use outdoors.
• Do not operate where aerosol (spray)
products are being used or where
oxygen is being administrated.
• To disconnect, turn all controls to the
o (“0”) position, then remove plug
from outlet.
• Do not unplug by pulling on cord. To
unplug, grasp the plug, not the cord.
• Do not use the machine if it is wet.
• Please do not touch the mat or material
during the cutting process, even if the
mat or material has stopped moving.
Only handle the mat or material once
the machine has fully ejected it.
• If the LED lamp is damaged or
broken, it must be replaced by the
manufacturer or its service agent or a
similarly qualied person, in order to
avoid a hazard.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...