54 – Embroidery Stitch Out
Corner Check
Design Placement
Use corner check to trace the four corners of the design to see
where the design will be stitched out on the fabric.
Each touch on the corner check button will move the hoop to
the following positions and in the following order: upper left,
upper right, lower right, lower left and then go back to the
current stitch position.
Use the design placement feature to place a design on an
exact location on your fabric without re-hooping. It can also
be useful when you want to embroider a design to exactly
match a specic spot on your project or next to a previously
embroidered design. Use the corner icons to place the design
in a corner of the hoop. Use the dierent arrows to freely place
your design.
Embroidery Stitch Out Pop-up Messages
The Embroidery Arm Needs to Calibrate
When the embroidery unit is attached, a pop-up message will
appear and inform you to slide o the hoop and clear the ma-
chine area for calibrating the embroidery arm. You will also be
reminded to attach a suitable embroidery foot.
Your Embroidery is Finished
A pop-up message and sound informs you that your embroi-
dery is nished. When the pop-up is closed the design will stay
loaded in embroidery stitch out and you can stitch the same
embroidery again, including any changes you have made.
To Next Page
Loading...
Need help?
General
