Singer SGR-20205 - Self-cleaning Function; Cleaning and Maintenance

9
ENGLISH
Self-cleaning
Only activate the self-clean when you want to activate the self-cleaning
system. Never activate the self-clean function when ironing.
The self-clean function removes scale and impurities. The steam generator
has an intelligent reminder cleaning mode which activates after continuous
steam ironing over a total of 25 hours. If you are in a hard water area you can
perform the cleaning cycle sooner than the allocated 25 hours by following the
steps below:
The cleaning indicator light will illuminate to remind users to clean the
machine.
1. Hold the iron horizontally over the sink.To activate the self-clean function,
adjust the temperature control knob to the Max setting. Press and hold the
self-clean button for 3 seconds. The clean indicator light will fl ash, pull the
steam trigger once then remove hands from the handset, this will initiate the
cleaning function.
2.
CAUTION: It is hot!!! Hot water and steam will be ejected from
the holes in the soleplate along with any impurities. During the
cleaning process there is no need to hold the product.
3. The cleaning cycle takes approximately 1 minute. When the clean indicator
light stops fl ashing, the cleaning cycle is complete, and you can switch off
your unit and store when cooled.
4. To cancel the self-clean function, press and hold the self-clean button for 3
seconds. The clean indicator light will stop fl ashing.
WARNING: Do not attempt to pick up the handset while the clean indicator
light is fl ashing as hot water and steam may be ejected.
CLEANING AND MAINTENANCE
Before cleaning, fi rstly disconnect the power outlet and let the appliance cool
down.
1. Empty the boiler above a sink and rinse it a few times with clear water. Wipe
fl akes and any other deposits on the soleplate with a damp cloth or a non-
abrasive (liquid) cleaner.
NOTE: Do not use chemical, steel, wooden or abrasive cleaners to
scrape the soleplate.