Singer SRP-50 - Page 55

c
~
o~c
~
D
Partial knitting in pile knitting and
drive lace knitting
Set Russel Levers on Knitter and Ribber Carriages to I and
- positions respectively.
In pile knitting, start partial knitting after removing stitches
on Knitter using P Carriage .
Partial knitting by decreasing stitches
( 1) On the side opposite Carriage, push Knitter needles
to be decreased back to · A position, and push up
Ribber needles to be decreased to D position.
(If partial knitting is required on both sides, push
only Knitter needles to be decreased back to A posi-
tion on the Carriage side.)
(2) On both sides of Ribber Bed push end 4 or 5 working
needles up to D position and then back to C posi-
tion(*) instead of bringing Ribber needles with P
Carriage because it cannot be used in partial knitting.
(3) Knit one row.
(4) To prevent a hole, bring yarn under the first inside
needle in D position .
(If
partial knitting is required on both sides, push up
Ribber needles to be decreased to D position on the
side opposite Carriage.)
(5) Work the same manner as done for step (2) and knit
one row.
(6) Repeat steps (1 )-(5).
Partial knitting by increasing stitches
On the side opposite Carriage, push Knitter needles back
to A position and push up Ribber needles to D position for
the width to be shaped by partial knitting.
Push Knitter needles to be increased to 8 position and push
back Ribber needles to be increased to C position .
Other operations should be carried out in the same manner
as decreasing.
- 51 -