Singer SRP-50 - Handling Needle Issues

If a needle has been damaged ...
A Ribber needle can be replaced in the same manner as
applied for replacing a needle on Knitter.
1. Pull Needle Retainer out of Needle Bed .
2. Push damaged needle to D position and lift it out of
groove by lifting butt.
3. To replace a new needle, insert it into groove with its
hook first.
4.
Depressing needles with Needle Pusher, insert Needle
Retainer.
If you knit with Knitter only as
Ribber is connected ...
1. Disconnect Ribber Arm and Carriage from Knitter Car-
riage.
2. Lower Ribber to its fullest extent by pushing down
Drop Levers twice.
3. Install Knitter Arm and start. knitting.
To use Lace Carriage as Ribber is attached, refer to Knitter
Instruction Book for the special cares to take.
-55-