Singular Sound BeatBuddy - Page 27

26
• Enable/Disable
• Control Change (CC) - Settings for the CC commands the BeatBuddy follows. CC
commands can be numbered CC 0-127, each with a Value 0-127.
o Enable*/Disable - Toggle receiving all CC commands on/off
o Tempo (CC:80, CC:81, value 1-127) - When enabled, you can control the
BeatBuddy’s tempo using CC:80 to increase the tempo and CC:81 to
decrease the tempo. Example: When the BeatBuddy receives CC:80, Value
10 it changes the tempo to current tempo + 10 BPM. CC:81 decreases the
tempo by the Value amount.
• Enable*/Disable
o Half Time (CC:82, value 1-127) - The BeatBuddy enters Half Time mode at
the next measure. CC:82, value 0 goes back to Normal Time at the end of
the measure.
• Enable*/Disable
o Double Time (CC:83, value 1-127) - The BeatBuddy enters Double Time
mode at the next measure. CC:83, value 0 goes back to Normal Time at the
end of the measure.
• Enable*/Disable
o Mix-Vol (CC:108, value 0-100) - When enabled, the Mixer volume (main
volume knob that controls only the drum sound volume) can be controlled
by sending the MIDI message with a value ranging from 0 to 100. If
disabled, the BeatBuddy ignores all mixer volume commands it receives.
This parameter can be set to work with INC/DEC commands, read how in
Tempo Control.
• Enable*/Disable
o HP-Vol (CC:109, value 0-100) - When enabled, Headphone volume can be
controlled by sending the MIDI message with a value ranging from 0 to
If disabled, the BeatBuddy ignores all headphone volume commands it
receives. This parameter can be set to work with INC/DEC commands, read
how in Tempo Control
• Enable*/Disable
o Accent-Hit (CC:110, any value) - When enabled, the BeatBuddy will play
the current song part accent hit each time it receives the Accent-Hit MIDI
message. You can control the volume of the accent hit by changing the
value of the message ranging from 0 to 127. If disabled the BeatBuddy
ignores all Accent-Hit commands it receives.
• Enable*/Disable
BeatBuddy Manual
MIDI and the BeatBuddy