Singular Sound BeatBuddy - MIDI OUT Settings and Commands

28
BeatBuddy Manual
o Intro (CC:114, value 1-127) - When enabled, the BeatBuddy will trigger the
Intro of the song when an Intro message is received. If disabled, the
BeatBuddy ignores all Intro messages it receives. If the non-MIDI Intro
setting in the Main Pedal settings is disabled, the BeatBuddy starts without
playing the intro.
• Enable*/Disable
o Outro (CC:115, value 1-127) - When enabled, the BeatBuddy will trigger
the outro of the song when an Outro message is received. If disabled, the
BeatBuddy ignores all Outro messages it receives.
• Enable*/Disable
o Drum Set (CC:116, value 1-127) - When enabled, the BeatBuddy will
change the drum set when it receives this message. The value decides
which drumset is chosen, Value=1 is the first drum set, etc. If disabled, the
BeatBuddy ignores this message.
• Enable*/Disable
o Tap-Tempo (CC:117, value 1-127) - When enabled, if the BeatBuddy
receives this command, it enters Tap Tempo mode. This is a useful way to
enter Tap Tempo mode hands free if you have an external device that can
send this command. Sending out this command multiple times is like
tapping out the tempo with the pedal. When disabled, BeatBuddy ignores
this command.
• Enable*/Disable
o Enter/Exit Folder (CC:118, any value) - When enabled, receiving this
command enters the selected folder. If disabled, this command will be
ignored.
• Enable*/Disable
o Scroll Up/Down (CC:119, value 0-1) - When enabled, receiving this
command with either value 0 (down) or 1 (up) scrolls the current selection
on the Songs List. If disabled, the BeatBuddy ignores this command.
• Enable*/Disable
o Remote Main Pedal (CC:120, value >0 for press, value=0 for release) -
This emulates the main BeatBuddy Pedal being pressed and released. In
other words, this makes a MIDI controller act just like the Main Pedal.
Simply send CC:120 with any value other than 0 to emulate the press and
send CC:120 with value 0 to emulate the release. Both must be sent for this
MIDI command to function properly.
• Enable*/Disable
MIDI and the BeatBuddy
• Program Change (PC) - Enable/Disable the BeatBuddy responding to Program
Change commands.