43
BeatBuddy Manual
Changelogs
o Double Tap during stop / intro state
Outro enabled: BB will switch and play the outro
Outro disabled: BB will immediately cancel the intro and BB stops
o Change outro request from external footswitches to follow the same
behaviour as a midi request
MIDI
• Added support for successive transition MIDI commands
o This helps with the stability of quickly repeated Transition and Complete
Transition MIDI commands sent by the user
o Allows receiving both the Transition and Complete Transition commands
simultaneously
• Fixed Mute Pause MIDI activation issue
• Wake up BB when receiving MIDI Messages from sleep state
• Disable Internal MIDI Sync Output (from BB) when the BB is synced to an
external clock. This fixes the 'double clock' problem.
• Send Time signature every 3 seconds (approx). Keeps the time signature on the
Aeros synced with the time signature on the BeatBuddy (Aeros song must be
blank for the time signature to be changed)
• Added MIDI CC Inc / Dec for Headphones (CC:109) and Mix (CC:108) main
volume
• Display volume changes (Headphones and Mix) when changing them with MIDI
• Fixed bug where Next Part CC:102 command did not follow the BeatBuddy's set
MIDI Out channel
• Set MIDI merge as default MIDI Out value
• Use MIDI velocity for MIDI accent hit
• Song Player MIDI control logic update
o Go to stopped state when receiving MIDI stop message from paused
state
o Play outro when receiving outro message when stopped
• Add MIDI remote main pedal on CC:120
o Value > 0 : Pedal Press
o Value = 0 : Pedal Release
• Folder selection done through Program Change can now address up to 16,384
folders
New MIDI IN transitions message logic:
CC-113, value = 0: Quit transition
CC-113, value = 1...32: Start transition to part X (if part X exists)
CC-113, value = 33...125: Ignored, no part possible
CC-113, value = 126:
CC-113, value = 127:
Start transition to previous part
Start transition to next part
To Next Page
Loading...
